[Mar-2024] H35-211_V2.5-ENU Dumps Full Questions - HCIP-Access Exam Study Guide
Exam Questions and Answers for H35-211_V2.5-ENU Study Guide
NEW QUESTION # 76
In the FTTX network, which of the following principles is wrong when planning data for broadband services?
- A. If the outer labels of different PON ports are different, the inner labels can be the same
- B. If the outer labels of different PON ports are the same, the inner labels cannot be the same
- C. The network management should use QinQ VLAN
- D. The same PON port is marked with different outer labels for different services
Answer: C
NEW QUESTION # 77
The double-rate three-color marking (TrTCM) algorithm can guarantee the basic bandwidth (CIR) of users, and allow users to obtain additional bandwidth services (PIR) when the network is idle, improving the utilization of network resources.
- A. TRUE
- B. FALSE
Answer: A
NEW QUESTION # 78
The SIP user and the server complete the establishment, maintenance, and removal of a voice channel through a series of message interactions. Therefore, each information contained in the SIP message is unique, and there will be no single information with multiple values.
- A. False
- B. True
Answer: A
NEW QUESTION # 79
What are the main congestion management technologies in OLT? (Multiple choice)
- A. PQ+WRR
- B. WRED
- C. PO
- D. WRR
Answer: A,C,D
NEW QUESTION # 80
User A and User B belong to different city servers, and there is only one landline in both homes that can be used for conversation. If user A is calling user B, the number of transactions included in the entire conversation is?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: A
NEW QUESTION # 81
Configure the following commands on the OLT,
huawei ( config ) #lacp priority
[integer<U><0, 32767>linteger<U>< 0, 65535>}: 2048
(Port<K>Isystem<K>}: system
Based on the above configuration, which of the following statements is correct?
- A. Set the LACP priority of the port to 2048
- B. If the priority of the peer system is also configured as 2048, compare the port priority to determine the active end
- C. The range of system priority is 0-32767
- D. After configuration, the system priority of the device is higher than the default value
Answer: D
NEW QUESTION # 82
In a typical access network, when a large number of IPTV users are accessed through the OLT, in order to prevent a large number of IGMP join and leave messages generated on the user side from impacting the performance of edge routers, what function is generally recommended to be enabled on the OLT?
- A. Multicast vlan
- B. IGMP Snooping
- C. IGMP proxy
- D. Static group join
Answer: C
NEW QUESTION # 83
When it is detected that the CPU of the OLT main control board continues to rise, the following possible reasons are: (Multiple Choice)
- A. Cyber attacks
- B. Network loop
- C. User illegally logged in
- D. Rogue ONU
Answer: A,B,D
NEW QUESTION # 84
When the backbone fiber is broken or the OLT cannot detect the expected optical signal (LOS) alarm, the possible cause is: (Multiple Choice)
- A. The port laser is turned off
- B. Port backbone fiber failure
- C. There is a rogue ON U under the port
- D. All power off or failures under the port
Answer: A,B,D
NEW QUESTION # 85
Which of the following descriptions are wrong? (Multiple choice)
- A. Use the display esl online-info command to query the local and remote signaling port numbers.
- B. Under the SIP protocol, the default matching method is the longest match.
- C. Use the protocol1 support t command to modify the voice protocol supported by the device.
- D. Use the mg-software parameter t command to modify the digitmap matching method.
Answer: A,B
NEW QUESTION # 86
When planning FTTX access, you can generally configure uplink aggregation to improve the bandwidth and reliability of the uplink of OLT equipment. Which of the following statements are correct? (Multiple choice)
- A. The aggregation group can realize cross-board aggregation between two uplink boards
- B. The two port types configured for aggregation must be the same
- C. Aggregation group can realize cross-board aggregation between two Ethernet boards
- D. Link aggregation members can also be protected in active/standby mode
Answer: A,B,C,D
NEW QUESTION # 87
At present, operators pay more and more attention to the reliability of the network, and put forward various reliability requirements for the equipment of the access network, from the reliability requirements of a single node to the end-to-end reliability requirements, these requirements mainly include which of the following aspects? (Multiple choice)
- A. Downstream Protection Requirements
- B. Device hardware-level protection requirements
- C. Device software-level protection requirements
- D. Upstream Protection Requirements
Answer: A,B,C,D
NEW QUESTION # 88
The relationship between the priority carried by the OLT uplink outgoing packet and the priority queue of the outgoing port is one-to-one by default, that is, the priority 0-7 corresponds to the queue 0-7. When modification is required, it can be achieved by changing the priority policy in the traffic template.
- A. TRUE
- B. FALSE
Answer: A
NEW QUESTION # 89
After the ONU is powered on, the unconfigured ONU cannot be automatically discovered on the OLT. What is the reason for the impossibility?
- A. Unplanned ONU ID
- B. The actual distance from the ONU to the OLT is outside the range of the distance compensation distance configured by the OLT
- C. ONU hardware failure
- D. There is a rogue ONU, which interferes with other ONU and cannot work normally
Answer: A
NEW QUESTION # 90
When configuring the FTTB service on the U2000, which template needs to be configured for the registration of the MDU? (Multiple choice)
- A. Route template
- B. MDU SNMP template
- C. DBA template
- D. SNMP template
Answer: A,B,C
NEW QUESTION # 91
......
HCIP-Access V2.5 Free Update With 100% Exam Passing Guarantee: https://www.exams4collection.com/H35-211_V2.5-ENU-latest-braindumps.html
Real Exam Questions and Answers - Huawei H35-211_V2.5-ENU Dump is Ready: https://drive.google.com/open?id=1LY0LBMnfEMgXsj4KfuSfUvcYyF2MiG43
